12" Twin peaks

[Bigsingleboost]

Going to be putting these on my bike here in a few days do I need new break and clutch cables? I'm sure it will be tight.But figured I would ask first.

 

[Spazz]

12" don't require new lines... only thing you will need is 8" NAMZ extensions for hand controls.... TBW is long enuf

Sent from my Note4 using Tapatalk

 

[Bigsingleboost]

12" don't require new lines... only thing you will need is 8" NAMZ extensions for hand controls.... TBW is long enuf

Sent from my Note4 using Tapatalk

Thanks spazz! you the man! i ordered the 8" namz extensions from my other thread asking a bunch of questions. finally fixing to get off the ship and can't wait to get all of my goodies installed! Thanks again

 

[Khafre]

Does the use of the original lines with 12" twin peaks also hold true for Street Glide Specials with ABS? When I was calling around for estimates i was told that new lines would be needed.

 

[JoseyWales]

No new lines needed. Spazz is on point with his recommendation. I installed 12" Twin Peaks on my 2014 Street Glide Special and all I ordered was the 8" NAMZ extensions for hand controls.

 

[Yamahoe72]

No new lines needed. Spazz is on point with his recommendation. I installed 12" Twin Peaks on my 2014 Street Glide Special and all I ordered was the 8" NAMZ extensions for hand controls.

Josey, do you have a pic of the twin peaks installed?

 

[JoseyWales]

Josey, do you have a pic of the twin peaks installed?

Here you go Yamahoe.

Sent from my SM-N900V using Tapatalk

 

[Yamahoe72]

Here you go Yamahoe.

Sent from my SM-N900V using Tapatalk

Nice! Ill be installing the same ones soon

 

[Cliffb31]

I installed them yesterday. Very happy.

 

[CrBear]

That's a good look !

 

[Xtremeroller]

Is it the same with the 2012 street glides? My 10" twin peaks came in yesterday. I'm about to order the NAMZ hand control extensions tonight.

 

[Rodrig27]

2014 SGS Just installed 14" Twin Peaks. So far very pleased with them.

 

[TomA]

Those look nice Rodrig27 and welcome to the fun

 

[Xtremeroller]

I installed my 10" black twin peaks but now my throttle side grip drags on the bar. It has enough drag that I don't even need to use the cruise control function. I took the grip off and put a light coating of silicone grease on the bar, that helped a little but not like it should be. Any suggestions??

 

[Xtremeroller]

No one has had this issue??

 

[corey45k]

I installed my 10" black twin peaks but now my throttle side grip drags on the bar. It has enough drag that I don't even need to use the cruise control function. I took the grip off and put a light coating of silicone grease on the bar, that helped a little but not like it should be. Any suggestions??

I had an issue similar to this when I installed my 15" Burly's with Avon grips. While riding at cruising throttle, when I let go to decelerate, it would stick and stay open. All I did was loosen the switch housing a little, and pull it towards the end of the bar just a hair so there was just a minute amount of slop in and out with the grip. Problem solved!!


Sent from my iPhone using Tapatalk

 

[danoday]

I had that same problem on my bar install, my grip was not properly seated on the tps twist barrell at the end of the bar.

 

[Xtremeroller]

I'll give it a try and see what happens